Датчик измерения Keyence LK-2501

Controller

Описание
Получить КП

Model	LK-2501
Type	Amplifier unit, Long-distance*1 Controller
Measurement mode	High-precision mode,Long-range mode
Reference distance	350 mm (High-precision mode),500 mm (Long-range mode)
Measuring range	±100 mm (High-precision mode),±250 mm (Long-range mode)
Light source	Type	Visible red semiconductor laser
Wavelength	690 nm
Output	15mW
Laser Class	FDA (CDRH) 21CFR Part 1040.10	Class 3B Laser Product
Laser Class	IEC 60825-1
Spot diameter (at standard distance)	Approx. 0.7 mm (High-precision mode),Approx. 0.3 mm (Long-range mode)
Linearity	±0.1% of F.S. *2
Repeatability	10 µm3 (High-precision mode), 50 µm3 (Long-range mode)
Analogue output	Output voltage	±10 V (10 µm/mV)4 (High-precision mode), ±5 V (50 µm/mV)4 (Long-range mode)
Impedance	100 ?
Output current	4 to 20 mA (Applicable load: 350 ? max.)
Alarm output	NPN: 100 mA max. (40 V max.) (N.C.), Residual voltage: 1 V max.
Sampling cycle	1,024 µs
Other functions	Auto-zero, analog output holding when an alarm occurs, gain switching, response switching, span and shift adjustment of mirror surface measurement mode, changing the sampling cycle
Temperature characteristics	0.01% of F.S./°C
Rating	Power voltage	24 VDC ±10 %, Ripple (P-P) 10 % or less
Maximum current consumption	400 mA max.
Environmental resistance	Enclosure rating	IP67
Ambient light	Incandescent or fl uorescent lamp: 10,000 lux max.
Ambient temperature	0 to +50 °C (No condensation)
Relative humidity	35 to 85 % RH (No condensation)
Vibration resistance	10 to 55 Hz, Double amplitude 1.5 mm, 2 hours in each of the X, Y, and Z directions
Material	Polycarbonate
Weight	Approx. 515 g (including cable)
1 The LK-501 and LK-503 can both be used in High-precision mode or Long-range mode. 2 Linearity was obtained using KEYENCE’s standard target (Zirconia block gauge: LK-031/036, LK-081/086, LK-011, White ceramic block gauge: LK-501/503). 3 Repeatability was obtained using KEYENCE’s analogue sensor controller (RD-50) with the number of averaging measurements set to 64. Note: The ripple of the analogue output may be 1 mV or more due to co mmon mode noise when observed with an oscilloscope or a high-speed A/D conversion board. 4 When measurement is impossible, 12 V (31.2 mA) is output.

Получить КП

Для получения коммерческого предложения, пожалуйста, вышлите ваш запрос на электронную почту info@keyence-datchiki.ru с указанием требуемых позиций и реквизитами компании.