Датчик процесса Keyence FD-XS1

Sensor head Maximum rated flow rate 1 L/min

Описание
Получить КП

Model	FD-XS1
Supported pipe materials	Metal pipes, Plastic pipes (soft/hard) *1
Supported fluids	Liquids (water, oil, adhesive, grease, chemical solution, etc.) *1
Supported fluid temperature	0 °C (no freezing on the pipe surface) to 100 °C (Pipe surface temperature)
Clamp set model	Plastic pipe/tube attachment	FD-XC1R1, FD-XC1R2
Metal pipe attachment	FD-XC1M
Maximum rated flow rate	0 to 1000 mL/min
Zero cut flow rate	20 mL/min*2 (variable, default)
Display resolution	Instantaneous flow rate	0.1/1/10 mL/min (Displayed on controller)
Shot amount	0.001/0.01/0.1/1 mL (Displayed on controller)
Repeatability	Plastic pipe /tube attachment	Response time: 50 ms	F.S.	±0.6 %34
Instantaneous flow rate	±6 mL/min34
Response time: 500 ms	±1.9 mL/min*3
Metal pipe attachment	Response time: 50 ms	F.S.	±1 %34
Instantaneous flow rate	±10 mL/min34
Response time: 500 ms	±3.2 mL/min*3
Hysteresis	Variable
Integrated unit display	0.1/1/10/100/1000/10000 mL (displayed on controller)
Display method	Status indicator
Environmental resistance	Enclosure rating	IP65/IP67 (IEC60529) , IP68G (JIS C0920) *5
Operating ambient temperature	0 to 60 °C (No freezing)
Operating ambient humidity	35 % to 85 %RH (No condensation)
Vibration resistance	10 to 55 Hz, double amplitude 1.5 mm, 2 hours each for X,Y,Z direction
Shock resistance	50 G 11 ms, 3 times each for X,Y,Z direction
Material	Sensor head	Head body: PPS/PPSU, in-cable amplifier: PPS, cable: PVC, controller connector: PPS/PBT/POM
Clamp set	For plastic pipe	Body, fixing screw: PPS, detection surface: special rubber, pipe support rubber: FKM, sensor head fixing screw: SUSXM7
For metal pipe	Metal: SUS304/SUSXM7, detection surface: special rubber, clamp support rubber: FKM, sensor head fixing screw: SUSXM7
Weight	Approx. 230 g
1 Liquid must allow for the passage of an ultrasonic pulse, as well as not contain large air pockets or excessive bubbles. Readings may become unstable depending on the type of pipe. 2 The zero cut flow rate can be changed in the settings. When using the unit with a low flow rate range, perform an origin adjustment when the fluid is not moving if you change the zero cut flow rate. 3 This specification is valid when the flow velocity distribution is stable. This value does not take into account the effects of pulsation or fluctuations in flow velocity distribution due to facility factors. Convert the F.S. (full scale value) listed in the table according to the rated flow range. 4 The longer the response time is set, the more repeatability is improved. As a guideline, use v (50 ms/response time) times. *5 The connector part of the sensor head cable is IP65/IP67.