Датчик Keyence EX-V64P

Amplifier Unit PNP

Описание
Получить КП

Model	EX-V64P*1
Type	Amplifier Unit PNP
Shape	14 x 30 x 4.8 mm Thin profile
Measuring range	0 to 4 mm
A/D converting system	?
Display range	-19999 to +19999
Linearity	±0.3% of F.S.
Resolution (No. of averaging measurements: 64)	1 µm
Sampling rate	40000 samplings max./sec. *2
Display speed	20 times/second
Display power	7-segment 2-colour LED
Over-range alarm	±FFFF is displayed.
Control input	Timing input	10 to 30 V is applied.
Reset input
Auto-zero input
Judgment output: Inhibit input
Synchronization/external settings input
Control output	PNP: Applied voltage; 10 to 30 V
Controloutput	Setting method	Upper/lower 2-level setting x 4 patterns (selectable)
Control output	Signal	PNP open-collector (HIGH, GO and LOW): 100 mA max. (30 V max.)
Controloutput	Response time	0.075 ms (at maximum speed)
OFF-delay time	60 ms (ON/OFF selectable)*3
Strobe output	PNP: 100 mA max. (30 V max.), Residual voltage: 1 V max. (N.O.)
Control output	Alarm output	PNP: 100 mA max. (30 V max.), Residual voltage: 1 V max. (N.C.)
Analogue output voltage	Output voltage	±5V
Impedance	100 ?
Response time	0.075 ms (at maximum speed)
Temperature characteristics	0.07% of F.S./°C *4
Major functions	FLL, digital filter, auto zero, offset, calculation, measurement mode (15 types), judgment value memory (4 sets), decimal point shift, display digit changing, display of various errors, etc.
Rating	Power voltage	24 VDC ±10 %, Ripple (P-P) 10 % or less
Current consumption	240 mA or less
Environmental resistance	Ambient temperature	0 to +50 °C
Relative humidity	35 to 85 % RH (No condensation)
Vibration resistance	10 to 55 Hz, Double amplitude 1.5 mm, 2 hours in each of the X, Y, and Z directions
Weight	Approx. 235 g
1 The above data was obtained using an iron target (S45C, SS400, t=1 mm). When measuring aluminium, copper, or stainless steel targets, refer to the linear characteristics for these materials. 2 When the digital filter function is used, the sampling rate is 20000 sampling/sec. 3 NPN output can easily be converted to PNP output by connecting the optional OP-5148 PNP output converter. 4 When the distance between the sensor head and the target is within 50% of the measuring range.

Получить КП

Для получения коммерческого предложения, пожалуйста, вышлите ваш запрос на электронную почту [email protected] с указанием требуемых позиций и реквизитами компании.